Descargar Imprimir esta página

Diamond ENOTEC 340 3TV Instalación Y Uso página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11
6. CONTROLS
The controls of the appliance are situated at the front inside a protected recess.
switch:
to turn on the refrigeration system.
6. Thermometer:
to read the temperature in the counter.
appliance.
A)
Press key
3 "SET or P"
by pressing key
or
4 "UP"
thermostat, located on the side panel, immediately above the shelf (Model 3TV).
bottom section, for white wines (thermostat on the outside of the panel). +9°C in the middle section, for
rosé wines (thermostat inside cabinet, in centre section). +18°C in top section, for red wines to drink at
cellar temperature (internal thermostat in top section)
7. CHECKING CORRECT OPERATION BEFORE USE
Make sure that: 1.
the plug is connected; . the refrigeration unit switch is turned on (green light lit up);
3
. thermometer shows the desired temperature for the goods to be stored; . lights are turned on;
is firmly closed;
6.
appliance is not exposed to direct sunlight or to powerful lamps; . ambient
temperature does not exceed +30°C with 55% R.H. (climatic class 4); . there is sufficient ventilation for
the motor compartment; there is a clearance of at least 30 cm in front of the grill; . the cabinet is suitably
filled and shelves are not overloaded (max. 45 kg per shelf, equal to approximately 30 bottles).
8. REPLACEMENT OF INTERNAL LIGHT BULBS
1.
Switch off the appliance.
fluorescent tube with its protective cover from the top lamp socket.
lamp socket. . Remove the protective cover. . Replace the fluorescent tube. . Reassemble by
5
following the above instructions in reverse order (see fig. 6).
9. REPLACEMENT OF THE DOOR'S MAGNETIC GASKET
1
. Open the door.
2.
Take hold of the magnetic gasket with your hands and pull it out of the frame.
3
. Insert the new gasket and press it firmly down all around (see fig. 7).
Operator's guide
2. Light switch:
once to display the temperature set-point, which can be changed
. To adjust temperature of internal shelves, turn the relevant
5 "DOWN"
2
2.
Undo the screws which hold the top lamp socket in place. . Detach the
6
7
to turn on the light inside the display cabinet.
Thermostat:
to adjust the temperature in the
(see fig. 5).
4
8
4.
Take the tube out of the bottom
7
1. Refrigeration
Suggestions: +6°C in
5.
door
7
9
3
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO

Publicidad

loading

Este manual también es adecuado para:

Enotec 340 1tvEnotec 340 1tv- p