Burley Cub X Manual De Instrucciones Y Seguridad Del Propietario página 12

Locking the Brake
1
to lock the brake, slide the lever
to the right. to release the brake,
slide the lever to the left.
Installing Additional Lights
1
Fabric loops are located on the back of
the trailer fabric and should be used to
attach additional lights and/or reflectors.
12
ASSEMBLY & uSE
Adjusting the Handlebar
1
Bike Trailer Mode: Always rotate the
handlebar forward when using as a bike
trailer. the handlebar should be horizontal
and parallel to the ground, such that
the mark on the handlebar is aligned
with the bolt that attaches the cover.
Securing the Cover
Secure the buckle on the hook. the
webbing can be tightened by adjusting
the velcro on the strap (Figure 22).
ENG
2
Stroller Mode: rotate the handlebar
to serve as a handlebar while using
as a stroller. open lever to rotate
and close lever to lock in place.
1
DEU FRA ESP
WARNING
ALWAYS uSE tHE
JoGGInG tEtHEr WHEn
uSEd AS A StroLLEr
note
the handlebar lever tension is optimally
adjusted from the factory. If the handlebar
slips when lifting up or pushing down – or if
it makes excessive noise when rotating – the
lever tension can be fine-tuned by removing
the handlebar cover on the opposite side of
the lever. then release the lever, squeeze the
handlebar tube together and turn the barrel
nut in 180 degree increments. Adjust the
barrel nut to desired tension. then reinstall
the handlebar cover.
Installing the Flag
1
depress the yellow button and slide the flag
pole into hole on flag holder. to release, depress
the yellow button and lift flag pole out.
.
BURLEY.COM