Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and Connection
Installation and Connection
3
Insert the extraction keys (
the slots on each side.
\
4
Lower the extraction keys (
bottom, and pull out the unit halfway
while pressing towards the inside.
\
Be careful to avoid injury from the catch pins on
the extraction key.
5
Pull the unit all the way out with your
hands, being careful not to drop it.
30
ENGLISH
\
) deeply into
Installing the supplied GPS antenna
GPS antenna is installed inside of the car. It should
be installed as horizontally as possible to allow easy
reception of the GPS satellite signals.
1
Clean your dashboard or other surface.
2
Remove the separator of the metal plate
(
Å
).
3
Press the metal plate (
on your dashboard or other mounting
surface.
\
) toward the
You can bend the metal plate (Å) to conform to a
curved surface, if necessary.
4
Remove the separator of the GPS antenna
(
«
), and stick the antenna to the metal
plate (
Å
Å
) down firmly
).
«
Å
Notes on using the supplied GPS antenna («)
• Use the supplied GPS antenna («). Using the GPS
antenna other than the supplied one may cause a
drop in positioning accuracy.
• Depending on the type of car, reception of the GPS
satellite signals might not be possible with an inside
installation.
• Please install the supplied GPS antenna («) in an
area away from any antennas that are used with CB
radios or satellite televisions.
• The supplied GPS antenna («) should be installed
at a position that is spaced at least 30 cm (12 inch)
from cellular phone or other transmitting antenna.
Signals from the GPS satellite may be interfered with
by these types of communication.
• Painting the supplied GPS antenna («) with
(metallic) paint may cause a drop in performance.
Publicidad
