Intimus AutoShred 180 CP4 Instrucciones De Uso página 14

GB
Control Panel
Auto-On (blue)
This setting automatically starts the
shredder by loading paper into the
paper tray or inserting paper into the
manual-feed slot. When the paper
has passed through, the shredder
automatically stops.
Off:
This setting turns off all features of
the shredder. For safety reasons, we
recommend that you leave shredder
in the OFF position when it is unat-
tended or not in use.
Reverse:
In the unlikely event of a paper jam,
use the reverse setting to help clear
the cutters of paper that did not pass
through. IMPORTANT: Never attempt
to clear a jam using the reverse func-
tion until you have emptied the was-
tebasket.
Forward:
The forward setting can also be used
to help clear the cutters in the event
of a paper jam. This allows you to ma-
nually activate the shredder into cut-
ting mode.
14
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
LED status indicators
Overheat:
Red LED light indicates the shredder
has shredded continuously beyond
the maximum running time, has over-
heated, and will automatically shut off.
If this happens, switch the shredder to
Off for 45 minutes or longer before re-
suming normal operation.
Overload:
Red LED light indicates when too
much paper is inserted. Use the „Re-
verse" mode to back up and reduce
number of sheets.
Door Open:
Red LED light indicates the shredder
basket or top lid is not closed pro-
perly. Shredders with pullout was-
tebaskets feature a safety power cut
off upon bin removal. Make sure the
pull-out wastebasket is properly set
back into place and the blue "Power
On" indicator is lit.
Bin Full:
When basket is full, RED light will in-
dicate it needs to be emptied. While
lit, the shredder will not operate until
the wastebasket is cleared.
Feed Error:
RED light indicates paper in the paper
tray cannot be grabbed by the cutting
unit. Open lid to make sure papers are
unfolded and positioned properly.
Features:
Auto-Reverse Technology:
When shredder detects over-capacity shred-
ding, the motor will immediately stop and
reject paper before actual shredding begins.
Energy Saving with Auto-Switch off-Mode:
This setting switches the shredder off comple-
tely after 5 minutes of inactivity. (No standby
function!) For safety reasons, we recommend
that you leave the main power switch (Fig. 2/4)
in the OFF position when the shredder is un-
attended or not in use.
96414 1 12/21