IMPORTANT SAFETY INSTRUCTIONS
4
• Install the panel and the cover of control box securely. There is risk of
fire or electric shock due to dust, water etc.
• Use the correctly rated breaker or fuse. There is risk of fire or electric
shock.
• Do not modify or extend the power cable. If the power cable or cord has
scrathes or skin peeled off or deteriorated then it must be replaced.
There is risk of fire or electric shock.
• For installation, removal or reinstall, always contact the dealer or an Au-
thorized Service Center. There is risk of fire, electric shock, explosion, or
injury.
• Do not install the product on a defective installation stand. Be sure that
the installation area does not deteriorate with age. It may cause product
to fall.
• Never install the outdoor unit on a moving base or a place from where
it can fall down.
The falling outdoor unit can cause damage or injury or even death of a
person.
• In outdoor unit the step-up capacitor supplies high voltage electricity to
the electrical components. Be sure to discharge the capacitor completely
before conducting the repair work.
An charged capacitor can cause electrical shock.
• When installing the unit, use the installation kit provided with the prod-
uct. Otherwise the unit may fall and cause severe injury.
• Indoor/outdoor wiring connections must be secured tightly and the cable
should be routed properly so that there is no force pulling the cable from
the connection terminals. Improper or loose connections can cause heat
generation or fire.
• Safely dispose off the packing materials. Like screws, nails, batteries,
broken things etc after installation or svc and then tear away and throw
away the plastic packaging bags. Children may play with them and cause
injury.
• Be sure to check the refrigerant to be used. Please read the label on the
product. Incorrect refrigerant used can prevent the normal operation of
the unit.
• The appliance shall be stored in a room without continuously operating
ignition sources (for example: open flames, an operating gas appliance or
an operating electric heater.)
• Do not use means to accelerate the defrosting process or to clean, other
than those recommended by the manufacturer.
• Do not pierce or burn refrigerant cycle part.
• Be aware that refrigerants may not contain an odour.