Sebson TREIBER_LED15 Manual De Instrucciones página 6

Danger:
In case of damages or contact with water turn off this product immediately without tension and make sure
that a restart is no longer possible!
Danger:
Please keep this product away from children and animals!
Danger:
Do not cover the device with heat-insulating materials! This is a fire hazard!
Caution:
Avoid overloading the device, an overload can damage the device or cause a short circuit! Therefore,
please note the maximum power consumption in the technical data! Consider a power reserve of at least 15%!

This device is only suitable for operating LED lamps or LED luminaires!

Do not connect a dimmer! The connection of a dimmer can lead to damage or functional impairment of the
LED driver! The remodeling of this product is not allowed! The proper and safe functioning of the device
can no longer be guaranteed if it is modified! In addition, this will invalidate the warranty claim!

The manufacture does not accept any responsibility for injuries or damage resulting from improper use of
this product!

Any other use than the description may result in damage to the product. So the dangers are such as
electric shock, short circuit, fire etc.

This product is only suited for indoor-use and not for outdoor-use!

We reserve the right to make changes to the product, the packaging or the operating instructions as well as
printing errors.

Protect the product from external damage, heavy dirt, moisture and excessive heat!

In order that the warranty claim does not expire please use only the supplied items. Repairs may only be
done by an expert and only by using original spare parts!

In commercial institutions, the accident prevention regulations of the professional trade association for
electrical equipment and facilities must be adhered to.
Start up (see Fig.2):
Danger:
Before installing make sure that the circuit is interrupted! For installation, the work on the mains voltage is
required. Remove the associated mains fuse or deactivate the switch fuse! Check by using a voltage tester if the
line is de-energized. Make sure that the current circuit will not closed during the installation! There is danger to life
here!
Danger:
The installation of this product may be done only by a qualified person according the valid regulations for
electrical installation!
Danger:
Install the device at least 50cm away from highly inflammable materials such as insulating materials or
highly explosive liquids or gases! This is a fire hazard!

Observe the safety instructions and technical data before installing this product!

Choose a vibration-free, dry and non-conductive surface for installation!

To prevent damage to the cables, they must not be strongly bent, pulled or twisted during commissioning!

An electronic protection circuit switches off the LED driver in case of short circuit or overload in the
secondary circuit as well as in case of open circuit. After the fault has been rectified, the LED driver is ready
for operation again.
Ensure the correct installation of the live and outgoing cables:
Input (PRI): 200-240V AC 50/60Hz (Power supply line)
Note on installation:
L: Live wire (black)
N: Neutral conductor (blue or grey)
Output (SEC): 12V DC (LED light/consumer)
Note: The cable to the consumer should not exceed a length of 2m!
6