Publicidad
Step 6
å
Carefully stand your unit upright against the wall in its final location.
å
NOTE: The following instructions show your unit being fastened to a wall stud. If you are not fastening your unit to a
wall stud, go to the next step now.
å
1
- Locate the center of a stud in your wall near your unit and mark it with a pencil.
st
å
2
- Drill a 1/8" hole on the mark and into the stud in your wall.
nd
å
3
- Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
rd
Mark and drill
a 1/8" hole into
the wall stud.
1
st
433242
Electric drill with 1/8" bit
2
nd
3
rd
96
www.sauder.com/service
Page 11
Publicidad
