Publicidad
Step 10
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten
the mounting screw.
å
Fasten the LEFT DOOR (G) to the LEFT END (A) as shown
in the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
å
Fasten one PULL (4) to the LEFT DOOR (G). Use two 5/8"
MACHINE SCREWS (11).
å
Repeat this step for the RIGHT DOOR (H).
å
See the next step for DOOR adjustments.
A
433242
B
G
4
www.sauder.com/service
Stop
Mounting
screw
Adjusting
screw
H
4
5/8" MACHINE SCREW
(4 used for the PULLS)
17
Hinge
11
Page 15
Publicidad
