Axxess AXAC-CH4 Instrucciones De Instalación página 6

Idiomas disponibles

INSTALLATION

With the ignition cycled off:

1.. Remove.the.harnesses.from.the.factory.radio,.then.install.the.AXAC-CH4 vehicle harness in.

between.

2..Connect.the.AXAC-CH4 vehicle harness.to.the.AXAC-CH4 interface harness.

3..Connect.the.AXAC-CH4 interface harness.to.the.AXAC-CH4 interface.

4..Make.sure.the.camera(s).is.connected.to.the.appropriate.input.

5..Make.sure.the.interface.has.been.configured.beforehand.as.shown.in.the.Configuration.

section..Failure.to.configure.the.interface.will.result.in.the.interface.not.functioning.properly.

AUX-IN

PROGRAMMING

For models with/without a factory backup camera:

1. Cycle.the.ignition.on.and.wait.until.the.LED.in.the.interface.comes.on.

. Note:.If.the.LED.doesn't.come.on.within.a.few.seconds,.yet.blinks.instead,.turn.the.key.to.the.off.

position,.disconnect.the.interface,.check.all.connections,.reconnect.the.interface,.and.then.try.again.

2..Test.all.functions.of.the.installation.for.proper.operation.