Publicidad
Enlaces rápidos
Model #
252Wa
Kid's Rocker
Assembly Instructions
Congratulations!
This fine piece of furniture will make a handsome
addition to your home. For the best results, start by
reading both the Assembly Instructions and
Finishing Hints before you begin your project.
For normal household use only.
recommended for commercial use.
Always keep child in view while
in rocker. Never leave child unattended.
Never lift the rocker with a child
in it. When moving the rocker, always lift under the
seat; never under the arms.
Do not climb or stand on this
piece of furniture.
Use care and caution to
assemble this chair exactly as shown in the
assembly instructions.
P.O. Box 2827
Eugene, OR 97402 USA
Service Policy:
which are defective, missing or damaged
during assembly. Please contact Whittier
Wood Products customer service department
directly (by phone, fax, mail or email) for
replacement parts.
Hours:
Our friendly customer service staff
can be reached Monday-Friday 7:00 a.m. to
5:00 p.m. (Pacific Time). A message can be
left 24 hours a day, 7 days a week.
To Order:
Provide the complete furniture
model number (upper left corner of this
page), part letter, production code, quantity
needed, reason for replacement and your full
name and address along with a telephone
number in case we need to contact you.
Parts ship from our Eugene, Oregon factory
within 1 or 2 business days from the time
we receive the request. Please allow 5-10
business days for delivery.
Outside U.S. or Canada: 541-687-0213
Outside U.S. or Canada: 541-687-0213
F F a a x: x: 5 5 4 4 1 1 - - 6 6 8 8 7 7 - - 2 2 0 0 6 6 0 •
0 • www
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Read both the Assembly Instructions and Finishing
Hints completely before beginning.
Store the parts: 1) in their box; 2) in a dry place; 3) in
temperatures ranging from 40° to 90°. (Not on a cold,
possibly damp, cement floor.)
Inspect your furniture periodically for any loose glue
joints or screws, or any other problem which may
be affecting the stability of your furniture. Tighten or
repair as needed.
Production Code:
VN
We will replace any parts
www. . w w h h i i t t t t ie ier r w w oo
ood d . . c c om
om
Rev. 1/07
Publicidad
Manuales relacionados para Whittier Wood Products 252Wa
Resumen de contenidos para Whittier Wood Products 252Wa
- Página 1 Model # 252Wa Kid’s Rocker Assembly Instructions Service Policy: We will replace any parts which are defective, missing or damaged during assembly. Please contact Whittier Wood Products customer service department directly (by phone, fax, mail or email) for replacement parts.
- Página 2 252Wa Kid’s Rocker — Parts List Before beginning assembly, check that the quantities of the parts received match those on the parts list below. A — Rocker Runner — Qty. 2 B — Leg — Qty. 4 C — Long Front Stretcher — Qty. 1 D —...
- Página 3 After the back is in place, put a little glue on the tapered ends of the Wood Wedges (M) and pound them into the slots in the bottom of the Backposts (G) as shown in FIGURE 2. 252Wa (Rev. 1/07) — PAGE 3...
- Página 4 The stretchers must face side to side and be on the end farthest from the seat. Repeat for the other pair of legs with the Short Back Stretchers (K). See FIGURE 4. PROCEED IMMEDIATELY TO STEP 5 WITHOUT DELAY. PAGE 4 — 252Wa (Rev. 1/07)
- Página 5 See FIGURE 6. With the rocker laying on its side, hammer a Brad (O) through the inner edge of the rocker runners into the leg chucks. See FIGURE 6A. 252Wa (Rev. 1/07) — PAGE 5...
- Página 6 Be careful not to scratch the backpost with the arms while doing this. Insert #8 x 2¼" Brass Pan Head Screws (N) through the holes in the backposts into the arms and tighten firmly. See FIGURE 7. PAGE 6 — 252Wa (Rev. 1/07)
- Página 7 Modelo # 252Wa Silla mecedora para niño(a) Normas para obtener servicio: Reemplaza- remos las piezas que tengan defectos, falten o se Instrucciones para Armar dañen durante el armado. Sírvase comunicarse con el departamento de servicio al cliente de Whittier Wood Products directamente (por teléfono, fax, correo o e-mail) para obtener piezas de repuesto.
- Página 8 252Wa Silla Mecedora Para Niño(a) INSTRUCCIONES PARA ARMAR HERRAMIENTAS NECESARIAS: Destornillador Phillips, pegamento para madera, martillo de goma o martillo protegido. PARA INSTALAR LAS PATAS AL ASIENTO IMPORTANTE: IMPORTANTE: 4) Con el asiento (H) boca abajo sobre una superficie suave, unte pegamento uniformemente en los cuatro orificios para ¡ANTES DE ARMAR, LEA LAS SUGERENCIAS...
- Página 9 No. de modèle 252W Fauteuil à bascule pour enfant Politique de service : Nous remplacerons toutes les pièces défectueuses, manquantes ou endom- magées pendant le montage. Veuillez contacter Instructions de Montage directement le service clientèle de Whittier Wood Products (par téléphone, fax, courrier ou e-mail) pour obtenir les pièces de remplacement.
- Página 10 252Wa Fauteuil á Bascule Pour Enfant INSTRUCTIONS DE MONTAGE OUTILS NÉCESSAIRES: Tournevis cruciforme, colle à bois, maillet en caoutchoue ou maillet rembourré. ASSEMBLAGE DES PIEDS AU SIÈGE IMPORTANT: IMPORTANT: 4) Placez le siège (H) face en bas sur une surface protégée.