Publicidad
FIG. 5
TO ATTACH ROCKER RUNNERS:
NOTE: The longest extension of the runner should be toward the back of the chair.
5) Spread glue in the holes of the Rocker Runners (A). To put the runners on the legs, place the
front hole on the front leg first, and the back hole on the back leg. There should be a little give if
the holes don't quite line up, so that the back leg can be pushed slightly toward the front leg. See
FIGURE 5.
A
B
FIG. 6
H
TO SECURE LEGS AND ROCKER RUNNERS
6) Screw a #6 x 1¼" Black Pan Head Screw (P) through each leg chuck into the seat and through
both stretchers into the legs. The screws must be inserted at such an angle so that they do not go
through the other side of the seat or leg. See FIGURE 6.
With the rocker laying on its side, hammer a Brad (O) through the inner edge of the rocker runners
into the leg chucks. See FIGURE 6A.
C
To insert screw at proper angle, the screw
head should be approximately 1/2" from the
P
nearest surface when starting screw.
P
A
K
O
B
A
FIG. 6A
252Wa (Rev. 1/07) — PAGE 5
Publicidad
