TFA 30.3054 Instrucciones De Uso página 11

TFA_No. 30.3054_Anleit_03_23
Wireless Thermo-Hygrometer
• To connect more transmitters, repeat steps 1 to 5. The correct switch position for the
transmitters 1-8 can be found in the table. 3 transmitters are included, the base station
is expandable to a total of 8 transmitters (optional).
Switch (D 6)
1 2
down down
down down
down up
down up
up down down
up down up
up up down
up up up
— —
— —
6.2 Installation of the base station
• Open the battery compartment of the base station and insert four new batteries 1.5 V
AAA, polarity as illustrated.
• All LCD segments will be displayed for about a few seconds.
• Close the battery compartment again.
• The measurements of the installed transmitters will be transmitted to the base station.
The radio-controlled reception symbol appears.
• If the reception is successful, on the display appear the temperature and humidity of the
respective transmitter, the temperature trend symbol and the symbol of the comfort
level.
• The radio-controlled reception symbol disappears.
• In the display section 4 appears automatically the measured values of the internal sen-
sor.
• If the values are not received from a channel or if no transmitter is installed, "- -"
appears on the display. Check the batteries and try it again. Check if there is any source
of interference.
• You can start the initialization manually.
• Press the CHANNEL / + button until the arrow appears on the desired channel. If you
want to search for all installed transmitters, select the internal sensor (IN).
20
06.03.2023 15:15 Uhr Seite 11
Function
3 4
down — channel 1
up — channel 2
down — channel 3
up — channel 4
— channel 5
— channel 6
— channel 7
— channel 8
— down °F
— up °C
Wireless Thermo-Hygrometer
• Press and hold the CHANNEL / + button for three seconds.
• The radio-controlled reception symbol appears.
• The base station will scan the measurements.
6.3 Additional transmitters
• If you have installed more than three transmitters, the measurements for transmitter
4-8 appear on the display section 4.
• Press the CHANNEL / + button to select the display section 4. The arrow appears on the
corresponding display section.
• Press the CHANNEL / + button to change between the installed transmitters.
• Press the button again after showing the last installed transmitter, on the display
appears the circle symbol. On the display section 4 appear in sequence, the values of
the internal sensor and the fourth to eighth transmitter. Press the button again to de-
activate the function.
• On the display appear again the measured internal values.
6.4 Temperature display
• Press and hold the MIN/MAX / – button in normal mode to change between °C (Celsius)
or °F (Fahrenheit) as temperature unit.
6.5 Display of the temperature tendency
• The trend pointer on the display indicates if the temperature values are increasing,
steady or decreasing.
6.6 Comfort level
• On the display appears a friendly face (RH 45...65%), a neutral face (RH < 45%) or sad
face (RH > 65%) to indicate the comfort level of the climate.
RH < 45% RH 45...65%
dry comfortable
6.7 Maximum and minimum values
• Press the MIN/MAX / – button.
• MAX appears on the display.
• On the display appear the maximum values since the last reset.
RH > 65%
wet
21