Jacto GM-12 Manual Del Operador página 11

4.1. Assembly
Follow the steps below to assemble Jacto GM-12 granular spreader.
• Fit the spreader handle into the articulation assembly using the cotter pins
and washers from the assembly kit.
articulation
assembly
• Then fit the lock pin and cotter pins as shown below;
1)
lock pin
cotter pins
• Remove the tank fairing;
1)
OBS.: Jacto GT-18 tank is sold separately.
• Insert the hose through the clamp, fit it into the tank outlet, and tighten the
clamp.
1)
tank outlet
clamp
hose
• Insert the other end of the hose through the fairing and screw it back onto
the tank.
cotter pins
Spreader
handle
washers
2)
2)
fairing
2)
ATTENTION!
Do not over-tighten any parts.
• Then, insert the hose through the clamp into the
the clamp.
1)
hose
hose clamp
delivery tube
4.2. Adjusting the strap
The equipment tank has an anatomical shape, providing greater comfort to the
operator. With a simple strap adjustment, the operator can position the equip-
ment correctly on his back.
• Pull the straps down to adjust them as needed.
A
pull strap
down
5. Operating the equipment
ATTENTION!
Do not operate your equipment if parts are missing.
Replace any defective parts before use. Misusing the
equipment can result in malfunction and personal injury.
ATTENTION!
When operating the spreader, wear personal protective
equipment (PPE), such as boots, gloves, protective
eyewear, and a face mask.
delivery tube and tighten
2)
B
strap lock
11/29