Publicidad
Idiomas disponibles
Idiomas disponibles
5.1. Using the equipment
Follow the steps below to operate your equipment correctly:
• Remove the tank lid.
• Insert the strainer and pour the product to be used in the application.
• Remove the strainer and close the tank lid correctly to avoid waste.
• To apply:
1.
Open the handles of the spreader.
2.
Insert the spreader in the desired location (up to 8 cm deep).
3.
And close the handles, so the dosage is released.
• Repeat these steps until the end of the application.
1)
6. Important information for users
6.1. Cleaning and Maintenance
Keep your equipment in good condition at all times. A well-maintained device is
efficient and easy to operate. Due to contact with various granules, cleaning the
equipment after every use is necessary. To do so, follow the steps below:
12/29
2)
3)
ATTENTION!
When handling the spreader, wear personal protective
equipment (PPE), such as boots, gloves, protective
glasses, and a face mask.
• Unscrew the articulation lock screw.
articulation lock
• On the other side, unscrew the cover screws.
• And remove the seal, the inner felt, the seal body, and the dosage regulating
cylinder.
dosage regulating
cylinder
• To remove the delivery tube, remove the cotter pin and then remove it, as
shown below.
cotter pin
delivery tube
• Clean all components that had contact with the applied product using a clean
cloth. Do not use any solvent.
• Replace damaged or worn parts.
screw
inner
cover
scrapper
seal
Publicidad
