Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up
•
Open the Homematic IP app on your smartphone.
Select "Add device".
•
•
To remove the electronic unit (B) from the frame, take hold of the
sides of the electronic unit and pull it out (see figure 6).
Turn over the electronic unit (B).
•
•
Remove the insulation strip from the battery compartment of the
wall thermostat.
•
The pairing mode is active for 3 minutes.
You can manually start the pairing mode for another 3 minutes by
pressing the system button (D) briefly (see figure 8).
•
Your device will automatically appear in the Homematic IP app.
•
To confirm, enter the last four digits of the device number (SG-
TIN) in your app, or scan the QR code. The device number can be
found on the sticker supplied or attached to the device.
•
Wait until pairing is completed.
•
If pairing was successful, the LED lights up green. The device is
now ready for use.
•
If the LED lights up red, please try again.
•
Select the desired solution for your device.
•
Allocate the device to a room and give the device a name.
5.2
Installation
Please read this entire section before starting the installation.
You can use the supplied clip-on frame (A) to mount the wall thermostat
or easily integrate it into an existing switch (see see „5.2.4 Installation in
multiple combinations" on page 37).
If you want to mount the wall thermostat with the supplied clip-on frame,
you can use
•
the supplied double-sided adhesive strips or
•
the supplied screws
to fix it to a wall.
34
Publicidad
