HomeMatic IP HmIP-WTH-1 Manual De Instalacion Y Uso página 39

Press and hold down the control wheel (E) to open the configu-
•
ration menu.
• Select the
by pressing the control wheel briefly.
6.2 Manual operation
In manual mode, the temperature is controlled in accordance with the
current temperature set via the control wheel (E). The temperature re-
mains activated until the next manual change. To activate the manual
mode, please proceed as follows:
Press and hold down the control wheel (E) to open the configu-
•
ration menu.
• Select the
by pressing the control wheel briefly.
• Turn the control wheel to set the desired temperature.
6.3 Selecting the desired temperature display
You can adjust the temperature to be displayed. You can also define
whether the humidity value shall be displayed or not.
Press and hold down the control wheel (E) to open the configu-
•
ration menu.
• Select the
by pressing the control wheel briefly.
• Turn the control wheel and select
- " " to display the actual temperature,
- " " to display the setpoint temperature,
- " " and
midity display and confirm by pressing the control wheel briefly.
Please note that the settings described below (chapter 6.4 to chap-
ter 6.9) can only be set up via the Homematic IP App or WebUI. For
more information, see the user manual on our homepage at www.
homematic-ip.com.
symbol by turning the control wheel and confirm
symbol by turning the control wheel and confirm
symbol by turning the control wheel and confirm
for alternating between the actual temperature and hu-
Operating modes and configuration
39