Publicidad
Table 3. System Configuration (continued)
Option
Drives
SMART Reporting
USB Configuration
Audio
Miscellaneous Devices
Table 4. Video
Option
LCD Brightness
Switchable Graphics
Table 5. Security
Option
Admin Password
Description
● AHCI: This option is enabled by default.
Allows you to configure the SATA drives on board. All drives are enabled by default. The
options are:
● SATA-0: This option is selected by default.
● SATA-1: This option is selected by default.
This field controls whether hard drive errors for integrated drives are reported during
system startup. This technology is part of the SMART (Self Monitoring Analysis and
Reporting Technology) specification. This option is disabled by default.
● Enable SMART Reporting
This field configures the integrated USB controller. If Boot Support is enabled, the
system is allowed to boot any type of USB Mass Storage Devices (HDD, memory key,
floppy).
If USB port is enabled, device attached to this port is enabled and available for OS.
If USB port is disabled, the OS cannot see any device attached to this port.
● Enable Boot Support
● Enable External USB Port
● Enable USB3.0 Controller
NOTE:
USB keyboard and mouse always work in the BIOS setup irrespective of
these settings.
This field enables or disables the integrated audio controller. By default, the Enable
Audio option is selected.
Allows you to enable or disable the following devices:
● Enable Microphone
● Enable Camera
● Enable Media Card
● Disable Media Card
NOTE:
All devices are enabled by default.
You can also enable or disable Media Card.
Description
Allows you to set the display brightness depending up on the power source (On Battery
and On AC).
NOTE:
The Video setting will only be visible when a video card is installed into the
system.
This option enables or disables switchable graphics technologies. Allows you to set the
display brightness depending up on the power source (On Battery and On AC).
NOTE:
It should only be enabled for Windows 7 and later version of Windows or the
Ubuntu OS.
Description
Allows you to set, change, or delete the administrator (admin) password.
NOTE:
You must set the admin password before you set the system or hard drive
password. Deleting the admin password automatically deletes the system password
and the hard drive password.
Configuración del sistema
33
Publicidad
