Publicidad
Idiomas disponibles
Idiomas disponibles
The charging process starts as soon as the charger is plugged into both the proper electrical
outlet 230V~ and the tool.
• During the charging procedure, the handle of the tool will feel slightly warm to the touch. This
is normal.
• When no further use is planned for an extended period of time, disconnect the battery charger
from the outlet and the unit.
• Do not use the tool during the charging procedure.
Battery charging : The length of service between each charging varies depending on the type
of work you are doing. The battery in this battery grass shear has been designed to provide
maximum trouble-free life. However, like all batteries, it will eventually wear out. To obtain the
longest possible battery life, we suggest the following:
• Store and charge your battery grass shear in a cool area. Temperatures above or below normal
room temperature will shorten battery life.
• Never store the battery grass shear with the battery in a discharged condition. Recharge the
unit immediately after it is discharged.
• All batteries gradually lose their charge. The higher the temperature is, the faster they lose
their charge. If you store your battery grass shear for long periods of time without using it,
recharge the battery every 6 months. This will extend battery life. Do not charge the battery
pack when the air temperature falls below4 ºC or above 40 ºC. Following these safety measures
will prevent damage to the battery pack.
1. Plug the charger adaptor into an appropriate AC power outlet. Connect the AC adaptor
charger plug into the charging socket of the battery grass shear and to start charging.
2. The battery will take approximately 3 hours to charge. Charging may take up to 5 hours due
to the level of charge left in the battery and the ambient temperature.
NOTE : A charge level indicator LED light will always be illuminated when the charger is plugged
in and the mains power is turned on. The charge indicator indicates the charge status of the
battery grass shear as shown below :
Switching on/off : illustration 4.2 to 4.3
WARNING : ENSURE THE BLADE DOES NOT TOUCH ANY OBJECTS
BEFORE TURNING ON THE PRODUCT.
To turn the tool ON, push and hold the safety lock-off button with your thumb, while pressing
the ON/OFF trigger switch with your forefinger. Once the trigger switch engages, you can
release the safety lock-off button and proceed with operation.
NOTE : The safety lock-off button reduces the risk of accidental starting.
To turn the tool OFF, release the ON/OFF trigger switch.
Condition
Charging
Fully Charged
Low Charge
221
Colour of LED's
Red
Green
Yellow
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Publicidad
