Publicidad
Idiomas disponibles
Idiomas disponibles
FR
Problems
ES
Product does
PT
not start
IT
Product does
not reach full
EL
power
Vibration
PL
or noise is
excessive
RU
Product
KZ
suddenly stops
UA
RO
*Over current means "Self-protection"."Self-protection" mode is a degraded mode, limited in
time (we recommend a maximum duration of 5 minutes) during which the use of the product is
made impossible so that the product can recover its initial state.
EN
9. END OF LIFE
Electrical products should not be discarded with household products. Used electrical
products must be collected separately and disposed of at collection points provided
for this purpose. Talk with your local authorities or dealer for advice on recycling.
The batteries are installed so that they can be removed only by an expert,batteries are
built into the device, and the device must be disposed of therefore only by a specialist.
10. ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. According to the
European Battery Directive, defective or used battery packs/batteries, must be collected
separately and disposed of in an environmentally correct manner. Please recycle where facilities
exist. Check with your local authorities or retailer for recycling advice. It will then be recycled
or dismantled in order to reduce the impact on the environment. Battery pack/ batteries can be
hazardous for the environment and for human health since they contain hazardous substances.
Probable causes
Battery is not charged
ON/OFF trigger switch
not set on ON position
Battery capacity too low
Bolts/nuts are loose
Battery discharged
Battery too hot
Product maybe over
current*
Solutions
Charge the battery
according to the
instructions included with
your model
Refer to chapter
"Switching on/off"
Charge battery
Tighten bolts/nuts
Charge battery pack
Let it cool down
Stop the product and wait
for 3 minutes to restart
228
Qualification
required
-
-
-
-
Publicidad
