Publicidad
Idiomas disponibles
Idiomas disponibles
Bluetooth®
[NUMBER DIAL]
1 Turn the volume knob to select a number (0 to 9) or character ( , #,
+).
2 Press S / T to move the entry position.
Repeat step 1 and step 2 until you finish entering the phone number.
3 Press the volume knob to call.
(or using the remote control)
1 Press the number buttons (0 to 9) to enter the phone number.
2 Press
to call.
[VOICE]
Speak the name of the contact you want to call or the voice command to
control the phone functions. (See also the following "Make a call using
voice recognition".)
[LOW]/[MID]/[FULL]: Shows the strength of the battery.*
[NO SIGNAL]/[LOW]/[MID]/[MAX]: Shows the strength of the current received signal.*
* Functionality depends on the type of the phone used.
Make a call using voice recognition
1
Press and hold
to activate the voice recognition of the connected
phone.
2
Speak the name of the contact you want to call or the voice command
to control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to the
instruction manual of the connected phone for details.
20
ENGLISH
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1
Press
to enter Bluetooth mode.
2
Turn the volume knob to select [CALL HISTORY], [PHONE BOOK] or
[NUMBER DIAL], then press the knob.
3
Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4
Press and hold one of the number buttons (1 to 6).
"STORED" appears when the contact is stored.
To erase a contact from the preset memory, select [NUMBER DIAL] in step 2,
store a blank number in step 3 and proceed to step 4.
Make a call to a registered number
1
Press
to enter Bluetooth mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO MEMORY" appears if there is no contact stored.
Bluetooth mode settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (page 21), then press the
knob.
3
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press and hold
to exit.
To return to the previous setting item, press
.
Publicidad
