Samsung Jet Bot VR50T95 Serie Manual Del Usuario página 34

Notes and cautions
Installation
NOTE
• Install the Clean Station in a place where the floor and wall are level.
• If the cleaning area is wooden floors, it is best to install the Clean Station
along the grain of wooden floors.
• If the power switch is off, the Jet Bot will not charge even if it is docked
on the Clean Station.
• Always keep the Clean Station on.
– If power is not supplied to the Clean Station, the Jet Bot cannot find it
and cannot automatically recharge.
– If the Jet Bot is left detached from the Clean Station, the battery will
drain naturally.
• Do not attach the Boundary Markers as (-----) shape.
– The Jet Bot may not detect it and cross the boundary.
Charging
NOTE
• If the battery overheats during charging, it may take longer to charge.
• When auto charging is not working, do the following:
– Turn the power switch (at the side the Jet Bot) off and on again.
– Unplug the Clean Station's power plug and then plug it back on.
– Unplug the Clean Station, and then check whether there is any foreign
matter on the charging pins and clean charging pins of the Jet Bot and
the Clean Station with a dry cloth or rag.
– Check for any obstacles such as reflective objects, chairs, etc. near the
Clean Station.
• If the Jet Bot is left detached from the Clean Station, the battery will drain
naturally.
– Try to keep the Jet Bot being charged on the Clean Station. (However,
turn off the power switch and leave the Clean Station unplugged when
planning to leave the house for long periods of time by going on a
business trip or vacation, etc.)
34 English