Publicidad
Idiomas disponibles
Idiomas disponibles
C) DIMENSIONS:
Fig.18) TRG13 - size specifications
D
TABLE 12) SIZE SPECIFICATIONS
A
B
80
125
Power (W)
L
1500
290
2000
290
2400
290
3000
290
4000
310
4500
335
6000
435
7500
610
9000
670
1200
810
D) DESCRIPTION OF USE:
It is best to set the desired temperature for the TRG13 heater before installation. If the TRG13 heater to be
adjusted is already installed, make sure that the power supply is disconnected. Use a Phillips screwdriver to
loosen the 4 fixing screws at each corner of the top cover, then remove the top and set the requisite
temperature. It is also possible to manually reset the thermal fuse after removing the top part. Before
connecting to the power source for the first time, make sure the heater is completely immersed and, in the
case of a closed system, the closed space has been bled of air.
The requisite temperature is set using the scale on the control knob. Turning it clockwise increases the value,
turning it in the opposite direction lowers the value. If the temperature in the system is lower than the set
temperature, the heater heats. When the set temperature is reached, the circuit opens, the heater no longer
heats.
It is reclosed when the media's temperature drops to the thermostat switching differential ( see Table No.
18).
If a thermal fuse is fitted, it is necessary to manually reset this thermal fuse. Remove the top part of the cover
and press the manual reset button with a blunt instrument (max diameter 5 mm). When resetting, it is
necessary to overcome the resistance of the thermal fuse spring, correct resetting is accompanied by a click.
• info@thermis.cz • www.thermis.cz •
Ln
L
E
C
120
Standard version
Ln (non-heating)
50
50
50
50
50
50
50
50
50
50
• (+420) 545 226 177-184 •
C
D
38
Version with extended non-heating part
L
390
390
390
390
410
435
535
710
770
910
• Thermis, spol. s r.o. • Mateří 14 •
• 614 00 Brno • Czech Republic •
EN
B
A
E
9
Ln (non-heating)
100
100
100
100
100
100
100
100
100
100
Publicidad
