Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING
For your own safety, never connect the
plug to power source outlet until all assembly steps
are completed and you have read and understood the
safety and operational instructions.
NOTE: Move all parts to the desired work site
before assembling them together. Follow the
assembly instruction and carefully assemble the
UP
tool with the help of a second person.
TRANSPORTING THE SAW (FIG. 1)
To avoid damage, never carry the miter saw by the switch
handle, the cutting arm or the miter handle. ALWAYS use the
designated carrying handle.
To lock the cutting head: When transporting or storing the
miter saw, the cutting head should always be locked in the
down position.
1. Press the cutting head down to its lowest position.
2. Push the hold-down latch into the locking hole.
CUTTING HEAD (FIG. 2)
WARNING
To avoid injury and damage to the saw,
transport and store the miter saw with the cutting
head locked in the down position. Never use the
hold-down latch to hold the cutting head in a down
position for cutting operations.
Raising
1. Push down slightly on the switch handle (1).
2. Pull out the hold-down latch knob (2).
3. Allow the cutting head to rise to the up position.
Locking
When transporting or storing the miter saw, the cutting head
should always be locked in the down position.
1. Push the cutting head down to its lowest position.
2. Push the hold-down latch (2) into the locking hole.
IMPORTANT: To avoid damage, never carry the miter saw
by the trigger switch handle or the cutting arm.
1
Fig. 2
INSTALLING THE BEVEL LOCKING HANDLE (FIG. 3)
1. Insert the bevel locking handle (1) onto the shaft (2) at an
approximately angle 30° as shown in Fig. 3.
2. Thread the hex screw (3) through the washer (4) into the
bevel locking handle (1).
3. Tighten the screw (3) with the 5 mm hex wrench.
INSTALLING THE MITER HANDLE (FIG. 3)
1. Insert the miter handle (5) into the hole in front of the miter
saw and align the hole (6) on the miter handle (5) with the
hole (7) in the front of the table.
2. Thread the screw (8) through the hole (7) in the table into
the hole (6) on the miter handle (5).
3. Tighten the screw (8) with a screwdriver.
Fig. 3
2
1
INSTALLING THE DUST BAG (FIG. 4)
Install the dust bag assembly (1) onto the exhaust port (2) on
the miter saw. Fit the connecting tube of dust bag assembly
and the exhaust port together.
NOTE:
• The dust bag assembly should be angled towards the
right side of the saw for best results. This will also avoid
any interference during the saw operation.
• To empty the dust bag, pull out the dust bag assembly
from the exhaust port. Open zipper on underside of bag
and empty into waste container.
IMPORTANT: Check frequently and empty the bag before it
gets full.
WARNING
metals. The hot chips or sparks may ignite sawdust
from the bag material.
2
Fig. 4
INSTALLING THE HOLD-DOWN CLAMP ASSEMBLY
(FIG. 5, 6)
Place the hold-down clamp assembly (1) in one of the
mounting holes (2) located behind the fence.
9
8
4
3
Do not use this saw to cut and/or sand
1
2
7
6
5
Publicidad
