Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE TOOL
THE LASER LINE
WARNING
For your own safety, never connect the
plug to power source outlet until all the adjustment
steps are complete and you have read and
understood the safety and operational instructions.
The laser line must always be correctly aligned with the blade
to ensure straight, even cutting. Your tool is equipped with
the laser cutting guide using a Class IIIa laser line.
The laser line will enable you to preview the saw blade path on
the stock to be cut before starting the miter saw. This laser
guide is powered by the transformed alternating current
supply directly through the power lead. The saw must be
connected to the power source and the laser on/off switch
must be turned on for the laser line to show.
WARNING
• AVOID DIRECT EYE CONTACT.
Laser radiated when laser guide is turned on. Avoid
direct eye contact. Always un-plug the miter saw
from power source before making any adjustments.
• NOTE: All the adjustments for the operation of this
machine have been completed at the factory. Due to
normal wear and use, some occasional readjustments
may be necessary.
• CAUTION: Use of controls or adjustments or
performance of procedures other than those specified
herein may result in hazardous radiation exposure.
• CAUTION: The use of optical instruments with this
product will increase eye hazard.
• Do not attempt to repair or disassemble the laser. If
unqualified persons attempt to repair this laser
product, serious injury may result. Any repair required
on this laser product should be performed by
authorized service center personnel.
• Laser Warning Label: Max. Output < 5 mW
Wavelength: 630−660 nm, Complies with 21 CFR
1040.10 and 1040.11. Class IIIa Laser Product.
(FIG. 23)
• Laser Aperture Label: AVOID EXPOSURE: Laser
radiation is emitted from this aperture. (FIG. 23)
Laser
warning
label
Laser
aperture
label
Fig. 23
TURNING LASER GUIDE ON (FIG. 24)
1. To turn laser on, press on/off rocker switch (1) to "I"
position.
2. To turn laser off, press on/off rocker switch (1) to "O"
position.
LASER GUIDE ADJUSTMENT
(FIG. 25, 26, 27, 28)
NOTE: All the adjustments for the operation of this machine
have been completed at the factory. Due to normal wear and
use, some occasional readjustments may be necessary.
Fig. 25
Laser line
A. Checking Laser Line Alignment (Fig. 25)
1. Set the saw to a 0° miter and 0° bevel setting.
2. Use a combination square to mark a 90° angled running
across the top and down the front of a board. This line will
serve as the pattern line to adjust the laser. Place the
board on the saw table.
3. Carefully lower the saw head down to align the saw blade
with the pattern line. Position the saw blade to the left,
center or right side of the "pattern line" depending on
your preference for the laser line location. Lock board in
place with hold-down clamp.
4. With the saw plugged in, turn on the laser guide. Your saw
has been preset with the laser line to the left side of the
blade.
WARNING
When making laser line adjustments,
keep fingers away from the ON/OFF trigger switch
to prevent accidental starting and possible serious
injury.
14
Fig. 24
1
TOP VIEW
Laser
line
Cutting
line
Workpiece
Cutting line
Blade
Publicidad
