Segway GT1P Manual Del Producto página 2

EN
Diagram and Functions
1
Front Brake Lever
Right Turn Signal
Headlight
Daytime Running Light (DRL)
Quick Release Lever
Folding Mechanism
Safety Button
Horn
Front Absorber
Front Reflector
Front Fork
Front Fender
Front Hub Motor
* For GT2 only
Front Wheel
Front Disc Brake
Side Reflector
01
Handlebar Functions
Dashboard
Handlebar
Rear Brake Lever
Left Turn Signal
Stem
Charging Port
Name Function
Footboard
Power on/off
Rear Absorber
Wake up the screen
Power Button
Ambient Light
Back to the previous
speed mode
Confirm Bluetooth
Rear Fender
password
Taillight & Turn on/off the headlight
Brake Light &
Left Control Turn on/off the cruise
Rear Reflector Switch
mode
Switch between 1WD
Rear Turn Signal
and 2WD
Mode switching
Rear Hub Motor
Activate the BOOST mode
Right Control
Rear Disc Brake
Switch
Switch to WALK
Battery Pack
mode
Kickstand
Speed up
Throttle
Turn Signal Turn on/off the left/right
Button signal
Horn Button Turn on the horn
Operation method
Press the Power Button to power on the scooter. Press and hold to power it off.
Press the Power Button to wake up the screen when the screen automatically dims.
When the scooter automatically enters PARK mode, press the Power Button to go back to the previous
speed mode.
While connecting to the scooter via the Segway-Ninebot app, press the Power Button to confirm Bluetooth
password.
Rotate the Left Control Switch clockwise/counterclockwise to turn off/on the headlight.
Press the Left Control Switch to turn on the cruise mode, and the scooter will cruise at a constant speed.
Press again to turn it off.
When the scooter is at a complete stop, press and hold the Left Control Switch to switch between 1WD and
2WD. * For GT2 only.
Rotate clockwise/counterclockwise to switch between speed modes.
1) Press the Right Control Switch to activate the BOOST mode. * In RACE mode only. 2) Press again or
switch the speed mode to turn it off. * For GT2 only.
For GT1: When the scooter is at a complete stop, press the Right Control Switch to switch to WALK mode.
At this point, press the Right Control Switch again to go back to the previous speed mode.
For GT2: When the scooter is at a complete stop, press and hold the Right Control Switch to switch to
WALK mode. At this point, press and hold the Right Control Switch again to go back to the previous speed
mode.
Twist the throttle to speed up.
Press the left/right side of the Turn Signal Button, the left/right turn signal will turn off after three blinks.
press and hold the left/right side of the Turn Signal Button, the left/right turn signal will keep blinking until
it is released.
Press the Horn Button, the scooter will beep once.
EN
Throttle
Power Button
Right Control Switch
Horn Button
Left Control Switch
Turn Signal Button
02