BaByliss PRO 4rtists SNAPFX FX895E Manual De Instrucciones página 10

get to tighten the screws after the
blades have been aligned.
ADJUSTABLE TAPER LEVER
The taper lever is positioned at
your thumb. You can hold the clip-
per in your hand and adjust the
lever at the same time – while you
are clipping.
The taper lever adjusts the close-
ness of the cut from a close cut
with the taper lever in the up posi-
tion to a longer length cut with the
taper lever in the down position.
To increase cutting length, slowly
push the lever down. To cut clos-
er, push the lever up. As different
cutting edges are used in each set-
ting, using the taper lever length-
ens the life of the clipper blades.
HAIR POCKET DOOR
The top housing of the FX895E
clipper has a removable, magnetic
door integrated into the top hous-
ing, allowing for easy access to and
Close Cut
Longer Cut
10
cleaning of critical moving parts.
To remove the magnetic door,
place fingers on the side tabs and
pull straight away from the unit.
To clean internal moving parts, use
the included small cleaning brush
to clear out hair from the housing
after the magnetic door has been
removed.
Once finished with cleaning the
moving parts of the clipper unit,
carefully place the magnetic door
back in its proper position. The
magnets should pull the door back
into place.
Too much hair can slow down
the hair clipper. Keep the clipper
on to remove hair. Then push the
taper lever back and forth quickly
several times. If you do this every
time, especially after frequent hair
cutting, the clipper blades should
remain free of cut hair. Oil the
blades after the above procedures.
BATTERY REMOVAL AND IN-
STALLATION
The FX895E clipper features re-
movable and rechargeable bat-
teries, so you can cut and style for
extended amounts of time with
minimal interruption.
Make sure the clipper switch is
in the OFF "0" position before
removing or installing battery.
To remove the battery, press on
the two tabs toward the bottom of
the unit and pull the battery out of
the bottom of the unit. Then place
into charging stand.
To install a new battery, line up
the tabs of the charged battery
with the slots on the sides of the
unit and slide up into the housing,
pressing firmly until battery clicks
into place.