BaByliss PRO 4rtists SNAPFX FX895E Manual De Instrucciones página 9

ON/OFF SWITCH
To operate clipper, simply slide
switch to ON (marked "I"). To stop
operation, set to the OFF (marked
"0") position.
VERY IMPORTANT: Blades must
be cleaned and oiled on a regu-
lar basis for proper functioning.
Failure to regularly clean and
oil the blades will void the
warranty.
CLIPPER MAINTENANCE IN-
STRUCTIONS
MAINTENANCE OF THE BLADES
Always apply oil to the blades be-
fore and after use. This will ensure
maximum cutting performance
and proper maintenance. Hold the
clipper away from your body in a
downward position and apply a
drop of BaBylissPRO lubricating oil
on the front and sides of the cutter
blade. Wipe off excess oil with a
soft, dry cloth.
HOW TO USE COMB ATTACH-
MENTS
To use the comb attachments,
turn the clipper to "0" position.
Slide the comb attachment onto
the top of the clipper blades and
then pull down and over the back
of the blade. To remove, pull up
on the back of the comb attach-
ment and then pull away from
the blade.
Fig. 2
REPLACING (REMOVING) BLADE
SET
Step 1. Unplug the unit and adjust
the taper as shown on illustra-
tion A.
Step 2. Remove the screws and
fixed blade. Save the screws.
Step 3. Lift off the small moving
blade and place new blade on
the plastic oscillator (see illustra-
tion B).
A.
Taper
Step 4. Replace the fixed blade us-
ing the screws and lightly tighten
them. Adjust the teeth to a gap
of 1 mm to 1.5 mm with the small
moving blade as centered and as
parallel as possible to the fixed
blade's teeth (see illustration C).
Fixe Blade
C.
C.
Small
Moving
Blade
IMPORTANT NOTE:
The top edge of the fixed blade
must be a minimum of 1 mm
higher than the top edge of the
moving blade and as centered as
possible. This is important so that
the moving blade does not come
in contact with the skin.
Be sure to add a few drops of
BaBylissPRO lubricating oil to the
blades before running. Don't for-
9
B.
Plastic Oscillator
Small
Moving
Blade
1 to 1.5mm