BaByliss PRO 4rtists SNAPFX FX797E Manual De Instrucciones página 10

ZERO-GAP ADJUSTMENT TOOL
IMPORTANT! Only ever attempt to
zero gap the blades using the ad-
justment tool provided and follow-
ing the instructions very precisely.
Adjusting the blades to zero gap
will enable you to achieve a closer,
more precise cut.
Step 1 – Using the screwdriver
included, gently loosen the two
small screws on each side of the
blade.
Step 2 – Slide the zero-gap tool
over the fixed blade until it is tight
against the back portion of the
moving cutting blade.
Step 3 – Using your fingers on
each side of the zero-gap tool,
push up until the black cutting
blade is even with, or slightly be-
low, the fixed blade.
Be sure that the blades are aligned
properly. The teeth of the smaller
blade (cutter) should rest slightly
below the upper edge of the larger
fixed blade (comb), approximate-
ly 0.5 mm to 1 mm apart (see Fig.
3). If the blades are not correctly
aligned, they may cut or scratch
the skin when trimming. Once the
blades have been aligned, tighten
the screws firmly.
Lame fixe (grande lame)
Fig. 3
Lame mobile (petite lame)
Step 4 – MAKE SURE THE MOVING
CUTTING BLADE DOES NOT EX-
TEND PAST THE FIXED BLADE.
WARNING: IF THE CUTTING
BLADE EXTENDS PAST THE
FIXED BLADE, YOU CAN POTEN-
TIALLY CUT A CLIENT.
Step 5 – Once the blade is ad-
justed to zero gap or your liking,
gently tighten the two screws
on each side of the blade while
holding the zero-gap tool in place.
If the blade is not adjusted to
satisfaction after testing, repeat
the adjusting process.
10
0.5 mm - 1 mm