Dantherm CALOREX V-PAC 12 Manual De Instalación página 20

OWNER/INSTALLATION MANUAL
4�2 OPERATING INSTRUCTIONS
Remember that at startup there is a 1 minute time delay before the heat pump starts
a� Power on�
Press to power the unit on or off. Note. a short
press will return the controller to main menu.
b� Temperature setting�
Press p and q to display and adjust the set
temperature. Press
main screen.
c� Mode Selection
Press M to enter mode.
Powerful mode indicator lamp lit.
Powerful
Smart mode indicator lamp lit
Smart
Silent mode indicator lamp lit
Silent
d� Heat mode selection
Press to switch between heating and cooling.
M
Heating= Heating indicator lamp lit and H on display.
Cooling= Cooling indicator lamp lit and C on display.
e� Defrosting
1. Automatic defrosting. When machine is defrosting
the heating indicator lamp flashes; after defrosting the
flashing stops.
20
IMPORTANT
to save settings and return to
2. Forced Defrosting. When machine is heating and
the compressor has been running continuously for 10
minutes. Press p and q together for 5 seconds. the
heating mode lamp flashes and defrost starts. When
defrosting is exited the display returns to normal.
During a normal defrost the heat pump may exhaust a
significant amount of vapour or mist into the air.
It is normal for ice to form on the evaporator fins but if
significant amounts of ice remain after a defrost, switch
the heat pump off and allow the ice to melt.
f� Clock Setting
Turn the heat pump off via the
enter the clock settings. Press
flashes. Using the p and q set the hour. Press
again to make the minutes flash and use the p and
M
q to set. Press the
main display. Press the
back on.
M
. Press to
and the hour
M
M
once more to return to the
to turn the heat pumps
1005759 ISSUE 5