Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
The microwave must be sufficiently ventilated. To that end, follow the instructions below:
-
Leave a space of 20 mm around the microwave.
-
Follow the indications in figure 3 about the size of the opening where you want to install
the microwave.
-
The furniture piece must be 20 mm thick.
Follow the procedure below to install the microwave:
1. Make sure the space requirements mentioned above are met.
2. Insert the microwave in its entirety into the furniture piece. Fig. 4
3. Centre the microwave in the furniture piece's recess. Fig. 5
4. Use the screws provided with the microwave to secure it to the furniture piece as shown
in figure 6.
-
The microwave must be placed in such way that the plug is accessible and that an effective
ground connection is provided in case of power leakage.
-
The microwave door must be closed to operate.
-
Should there be any manufacturing-product remains inside the microwave, leave the
microwave door open to ensure good ventilation. It is recommended to repeatedly heat up
a glass of water at high power in the first few uses.
4. OPERATION
Before cooking
Plug the microwave into the outlet. The display will light up, enter Standby mode, and show
1:00.
Microwave function
There are five power levels (100P, 80P, 50P, 30P, and 10P).
1. Turn the mode selector until it points to the icon with the desired power.
2. Turn the time/weight selector to increase or decrease the time. The selectable time range
is 0:10-60:00.
3. After selecting the time, press the "START/+30 s" button to start operation.
4. Once time is up, you will hear a buzzing sound.
Power level
High power
100P
Medium-High
80P
power
52
GRANDHEAT 2550 BUILT-IN STEEL
Function
Fast and complete cooking
Medium express cooking
Medium power
50P
Medium-Low
30P
power
Low power
10P
Warning:
-
When the microwave is operating at full power, power will automatically decrease after a
while to extend shelf life.
-
If you open the door during operation, you must press the "START/+30 s" button to continue.
-
If you remove food before the pre-set time has elapsed, you must press the "STOP/LOCK"
button to prevent the microwave from operating further.
Defrost
Use the defrost function to defrost by weight. The weight range you can select is 100-1500 g. In
this mode, a beep will sound to alert the user to turn the food over during operation.
1. Turn the mode selector until it points to the defrost icon to select "Defrost by weight", and
the display will show "dEF".
2. Turn the Defrost/Clock selector to set food weight.
3. After selecting the weight, press the "START/+30 s" button to start operation.
4. Once it finishes, you will hear a buzzing sound.
Advice on food defrosting time:
-
The time for defrost-by-weight mode is approximate. You may need more or less time
depending on the food type.
-
It is necessary to turn the food over during operation to obtain a uniform effect.
-
Defrosting normally takes longer than heating up the food.
-
If food can be cut by knife, the defrosting process can be considered completed.
-
Defrosted food should be consumed as soon as possible. It is not advisable to put it back
in the refrigerator or to refreeze it.
Clock
Clock setting:
1. In Standby mode, turn the mode selector until it points to the clock icon and press and hold
the "START/+30 s" button for more than 3 seconds to enter the clock's setting interface.
2. The hour digits will flash on the display. Set hour by turning Time/Weight selector.
3. After setting the hour, press the "START/+30s" button to enter minute setting mode. Set
the minutes by turning the Time/Weight selector.
ENGLISH
Steam cooking
Defrosting
Keep warm
53
GRANDHEAT 2550 BUILT-IN STEEL
Publicidad
