Descargar Imprimir esta página

SWR SM-500 Instrucciones De Funcionamiento página 7

Ocultar thumbs Ver también para SM-500:

Publicidad

Idiomas disponibles

Idiomas disponibles

• Treble Control ±15dB cut/boost (shelving point: 2kHz)
• Transparency Control ±15dB cut/boost (shelving point: 5kHz)
• Variable Graphic Equalizer with ±15dB cut/boost
• Band One: 31Hz to 160Hz
• Band Two: 80Hz to 320Hz
• Band Three: 200Hz to 800Hz
• Band Four: 400Hz to 1.6kHz
• Effects Blend Control
• Dual Concentric (Stereo) Master Volume Control
• Speaker On/Off Switch
• Power On/Off Switch
• Rack Handles
SM-500 REAR PANEL FEATURES
• Balanced XLR Output with select switch for Line or Direct Mode
• XLR ground lift & pad control
• Power Amp Assign Switch (selects Bridge or Stereo mode)
• Side Chain Effects Loop
• Tuner Output
• Two 1/4" jacks per side for Left and Right Stereo Output
• One Speakon
®
output jack per side for Left and Right Stereo Output
®
• One Speakon
output jack for Mono/Bridge operation
• (2) Speaker fuses: 3AG, 8 amp, fast-blo
• (1) Line Fuse: 3AG, 7 amp, slo-blo
• AC power cord receptacle
SM-500 SPECIFICATIONS
Note: All measurements were taken with a line voltage of 120VAC. All noise specifications are "unweighted." All
voltages and watts are "RMS." All measurements taken with tone controls set flat, Aural Enhancer at minimum.
POWER (minimum):
Bridge/Mono Mode
400 Watts @ 8 Ohms
250 Watts @ 16 Ohms
(minimum load = 8 Ohms)
Stereo Mode (per side)
SM-500 • 7

Publicidad

loading