Publicidad
Idiomas disponibles
Idiomas disponibles
2.2. Remote Control Unit
1. Mute audio output
2. Turn ON/OFF the receiver
3. Numerical pad
4. Display Main Menu
5. Exit current menu
6. Next Channel/Up
7. Reduce volume/Left
8. OK
9. Increase volume/Right
10. Previous channel/Down
11. Display EPG (Electronic Program
Guide)/Daily
12. Select audio language/Weekly
13. Display teletext/Timer
14. Show subtitles/Information current
program
15. Show channel info
16. Show favourites
17. Switch TV or Radio channels
18. Rotate photos 90º/Last channel
19. Timer
20. Digest function
21. Record
22. USB device connected
23. Zoom function
24. Stop
25. Previous chapter
26. Next chapter
27. Play/Pause
28. Rewind
29. Fast forward
3. SETTING UP
Use a SCART cable (Euroconnector) to connect your TV set to the SCART to TV
connector on the unit. You can connect your video recorder to the SCART to VCR
connector by SCART cable.
Connect your antenna cable to the ANT IN connector. You can use the LOOP OUT
connector to send the TV signal to other devices (VCR, TV,...).
Plug the power cable to an electrical outlet (please, make sure that the electrical
outlet is of the same type than the specified at the back side of the unit). Turn on your TV
set, select the SCART input and press POWER button in the remote control unit to enjoy
DVB-T programs in your TV set.
If you want to record a program, connect a USB device through the USB port.
3.1. Channels Initial Installation
34
Publicidad
