Infinite spa CHAMPION Manual De Instrucciones página 57

3
Installation
3.4 Connecting the SPA to the power supply
WARNING
• Observe the regional regulations (if in doubt, please contact your electricity supply company or your qualified electrical contractor).
• The connection to the power supply requires a permanent connection to its own power group that is not shared with any other
appliances. This power group must be fitted with a 16A fuse and the circuit must have an RCD (30 mA).
• Do not connect the SPA to the power supply if it is not filled with water.
ATTENTION This spa is equipped with a plug with a safety switch.
WARNING: Do not use the spa if the safety switch is not working properly.
Unplug the spa and contact a qualified electrician in order to rectify the problem.
Never bypass or open the safety switch yourself.
WARNING: Maintenance and repair work on the electrical components and any
necessary replacement of the safety switch may only be carried out by a
qualified electrician.
To ensure that the residual current circuit breaker is working properly, perform the following test sequence:
1. Insert the plug directly into the fixed power socket.
2. Press the "ON (RESET)" button; the operating indicator LED should now come on.
3. Press the "OFF (TEST)" button; the operating indicator LED should now go off.
4. Press the "ON (RESET)" button to use the device.
Do not use the SPA if the above testing sequence has failed. If that happens, switch off the SPA and contact your salesperson or a
professional electrical contractor.
• The plug must be pulled out of the socket to disconnect the device from the power supply.
• The ambient operating temperature must be between +4°C and +40°C.
• The device must not be used in the vicinity of a strong magnetic field.
• The device must not be dropped or exposed to damp.
• Ask for advice from the manufacturer or a professional electrical contractor if the device triggers a fault or the test sequence no longer
functions properly.
Caution! The use of a plug fitted with an RCD is not a substitute for basic electrical safety requirements and a properly installed power
supply.
WARNING Do not attempt to connect or disconnect the power plug while in the water or with wet hands.
4
Operation
4.1 Before using the SPA for the first time
Before using the SPA for the first time make sure that:
• there is sufficient water in the SPA
• nothing can block the flow of water in the pipes.
4.2 Control panel (display)
On / Off button for the filter system.
Manual SPA 2/4/6/8 2021 print NEU 18/11/21.indd 57 Manual SPA 2/4/6/8 2021 print NEU 18/11/21.indd 57
2.2 Den Whirlpool aufbauen
1.Öffnen Sie den Karton und ziehen Sie den zusammengefalteten Whirlpool und das
Sie für das Öffnen der Verpackung keine Werkzeuge mit Klingen (Messer, Cutter, et
Folie zu vermeiden.
2. Breiten Sie die Unterlegfolie an dem vorgesehen Platz aus und entfalten Sie darau
Bodenteil unten.
Intermediate switch
3. Öffnen Sie den oben am Filter-Heizungselement des Whirlpools befindlichen Luft
Füllschlauch auf.
4. Öffnen Sie das Luftventil an der Whirlpool-Hülle und stecken Sie den Füllschlauch
5. Pumpen Sie nun den Whirlpool auf, indem Sie auf der Bedienungskonsole die Tas
Display for SPA with air jets
Wenn der Spa richtig aufgepumpt ist, drücken Sie erneut die "BUBBLE" -Taste, um d
Intermediate plug
23.11.21 18:10 23.11.21 18:10