KlipXtreme KTE-006 Manual Del Usuario página 4

3. Basic operation
3.1 Charging the case and earbuds
1. To charge the case, plug the supplied USB cable into
a power source and the Type C end in the case's
charging port. The case starts charging automatically.
The LED screen displays the power level and blinks.
2. Once the case is fully charged it displays "100" in the
LED screen.
3. Proceed to unplug the charging case from the power
source and place the earbuds on the sockets of the
charging case.
4. While the earbuds are being charged the earbuds
LED indicator lights red on each side. When fully
charged, the LED indicators turn off. This takes about
an hour.
5. The fully charged earbuds have up to 4 hours of
playtime or up to 80 hours of standby time.
However, these times may vary depending on the
mobile device used, the usage profile, and the type of
files being played.
6. A low battery prompt will be heard to let you know
that the battery is below the acceptable level to
continue operating properly.
IMPORTANT: The touch button is
sensitive. Therefore, please make sure
to manipulate the earbuds by grabbing
them from the arm to avoid taping the
touch button by accident.
3.2 Turning your earbuds on or o
1. Press and hold the multifunction button on each
earbud for about 5 seconds. The "power on" prompt
is heard and the LED in both earbuds starts blinking
white.
2. As both earbuds synchronize, a prompt is heard
indicating that they are connected.
3. To turn the earbuds off, put them back in the
charging case or press and hold the multifunction
button on either earbud for about 5 seconds. The
"power off" prompt is heard and the white LED
blinks briefly on both sides, then it shuts off.
4. Advanced operation
4.1 TWS pairing
Simply take the earbuds out of the charging case or
turn them on as it has been instructed previously. The
earbuds sync with each other automatically and then
enter into mobile pairing mode.
Note: Before installing this product, please make sure
your device is Bluetooth
®
compatible.