Andis BTF-2 Instrucciones De Uso Y Cuidado página 6

or nicked blades to prevent injury. You can clean the excess hair from your blades
by using a small brush or worn out toothbrush. To clean the blades we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus while the
trimmer is running. Any excess hair and dirt that has accumulated between the
blades should come out. After cleaning, turn your trimmer off and dry blades with a
dry cloth and start trimming again.
When trimming is complete, turn trimmer off and remove the attachment comb
(if being used). Lightly brush excess hair from the blades. Blades should be handled
carefully and never bumped or used to cut dirty or abrasive material.
REMOVING AND REPLACING BLADE SET
To remove the blades, first unplug the trimmer from the electrical outlet. Turn the
trimmer upside down so teeth of blades are facing down. You may wish to set the
trimmer on a flat surface while performing these operations. Using a Phillips type
screwdriver, unscrew the two blade screws as shown in Figure F. Remove blade set
from trimmer. To install new blade set, align upper blade set and lower blade set
using the black blade guide (Figure G). Next, align slot in upper blade (smaller of
two blades) and center over yoke of trimmer (Figure G). Align screw holes of lower
blade (larger of the two blades) to housing screw holes (Figure G). While holding in
place, replace blade screws. Tighten down screws.
PROPER BATTERY DISPOSAL
Batteries may contain heavy metals such as mercury, lead, cadmium,
and nickel, which can be harmful to the environment when improperly
disposed of. Remove dead batteries from the unit and dispose of
properly. Some communities offer recycling or collection of batteries –
contact your local government for disposal practices in your area.
BLADE & CLIPPER/TRIMMER REPAIR SERVICE
When the blades of your Andis clipper/trimmer become dull after repeated use, it
is advised to purchase a new set of blades available through your Andis supplier.
Some blade sets can be resharpened – contact your Andis supplier or the Andis
Company for information on resharpening. If you wish your clipper/trimmer to
be serviced as well, contact your Andis supplier. To contact Andis directly,
please call our Customer Support Team at 1-800-558-9441 or email us at
support@andisco.com.
6