Denver MCA-210 Manual Del Propietário página 3

CONNECTING THE SPEAKERS
Connecting the speakers
1. Locate the block of 4 speaker terminals on the rear of
the unit.
2. Press the latch on the left channel red speaker terminal
(located on the right of the block) as shown in the
drawing.
3. Feed the exposed end of the red wire from the left speaker
into the terminal. Release the latch to grip the wire.
4. Press the latch on the black terminal and connect the
black wire.
2
5. Connect the black and red wires for the right channel in
the same way.
6. Check the finished wiring against the diagram below.
Make sure there are no bare wires free to touch as this
will damage the unit.