Kreg ACS-SAW Manual Del Propietário página 12

Toe-In Adjustment
ATTENTION
For smooth cuts, the face of the saw blade must
be parallel to the edges of the saw base. This alignment is made at the
factory and user adjustment, shown below, should only be necessary
in rare circumstances, such as significant impact to the saw base.
(1) Plunge the saw to the blade-change
position. (See Changing the blade in the
following section.) Verify the saw-blade
tooth contacts the anti-chip strip at the
front of the blade.
If there is a gap then proceed to step 3.
(2) Insert a business card or construction
paper approximately 0.010" thick between
a blade tooth and the anti-chip strip at the
rear of the blade. I f the gap is smaller than
0.010" no calibration is needed.
If the gap is larger than 0.010" thick proceed to step 3.
SETUP
1
2