Kreg ACS-SAW Manual Del Propietário página 13

(3) Position the track on a table with the front
end and the anti-chip strip edge of the
track extending slightly past the end
and edge of the table. Place the saw on
the track with the front of the saw
overhanging the end of the track
enough to allow access to the
front toe-in adjustment screws.
(4) Loosen toe-in adjustment screws just
enough to allow side-to-side movement
of the blade.
(5) Plunge the saw to the blade-change
position. (See Changing the blade in the
following section.) Adjust the saw so a
saw-blade tooth contacts the anti-chip
strip at the front of the blade.
(6) Tighten the front toe-in adjustment screw
closest to the blade to hold it in position.
SETUP
3
4
4
5
6