Kreg ACS-SAW Manual Del Propietário página 22

(3) Turn the guide track upside down
and slide a second track connector
into the T-slot.
(4) Thread in and tighten the set screws.
ATTENTION
Stagger the ends of the guide track
connectors for easier insertion into the second guide track.
(5) Slide the second guide track onto the
protruding track connectors.
(6) Align the track with a straight edge.
(7) Thread in and tighten the set screws.
(8) Turn the guide tracks right side up and
align the edges with a straight edge.
(9) Thread in and tighten the set screws.
GUIDE TRACK COMPONENTS
4
4
6
7
7
5
8
9
9
3
Stagger Ends