Descargar Imprimir esta página

Publicidad

Enlaces rápidos

WARNING
WARNING: Improper use or failure to follow instructions can result in explosive failure causing serious
eye or other injury. For safe use of this product you must read and follow all instructions. Do not leave
a pressurized sprayer in the hot sun. Heat can cause pressure build-up resulting in possible explosion.
Do not store or leave solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants
and full foot protection when spraying. Never use any tool to remove pump if there is pressure in sprayer.
Never stand with face or body over top of tank when pumping or loosening pump to prevent ejecting pump
assembly and/or solution from striking and injuring you. Never pressurize sprayer by any means other than
the original pump. Do not attempt to modify this sprayer. Replace parts only with manufacturer's original
parts. Never spray flammable, caustic, acidic, chlorine, bleach or other corrosive solutions or heat,
pressure, or gas producing chemicals. Always read and follow chemical manufacturer's instructions
before use with this sprayer as some chemicals may be hazardous when used with this sprayer.
Parts, Piezas, Pièces
6-1898
6-6141
Shut-off Handle
Hose Brown
Mango de cierre
Manguera Castaño
Tuyau Brun
Poignée du robinet
1-5941
1-5797
Nozzle .5GPM
Nozzle .5GPM
Tobera
Tobera
Buse
Buse
22180XP
6-7742
Extension wand
Vara de extensión, Rallonge (22790)
6-7711
Extension wand
Vara de extensión, Rallonge (22180, 22170)
6-4601
Repair Parts Kit Gaskets and Seals (not included)
Juego de piezas de reparación, empaquetaduras y juntas (no incluido)
Kit de pièces de réparation, joints et garniture d'étanchéité (non inclus)
Note: Your particular sprayer may not include all parts pictured above.
Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.
Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.
Congratulations!
You have just purchased a quality Chapin product.
Register Your Sprayer Online @ www.chapinmfg.com Questions? Do Not Return To Store.
Call us @ 1-800-950-4458 or www.chapinmfg.com
1. Hose to Tank
1A
Outlet Tube
Adapter
1C
Discharge/ Assembly
• Make sure white outlet tube is attached to outlet tube adapter (Fig. 1A).
• Insert the outlet tube portion of the discharge assembly into the tank adapter (Fig. 1B).
• Proper placement of white outlet tube (Fig. 1C).
Sk-1154-1
• Firmly insert the outlet tube adapter into the tank adapter (Fig. 1D) Lining up tab with notches
on the tank adapter.
• Firmly tighten the retaining nut to the tank adapter (Fig. 1E).
2. Nozzle
2A
Attach nozzle to shut-off handle or extension wand (22180, 22170).
2B
Attach nozzle to extension wand (22790).
22170 XP
22790XP
3. Pre-Use Check
1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.
2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are
6-3337
found, replace hose before using. Replace with original manufacturer's parts only.
Straps
3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and
Tirantes
Sangles
exterior of tank for signs of deterioration of body and bottom. Any sign of deterioration indicates
possible tank weakening and could result in explosive bursting under pressure. If any of these
signs are found, discard tank immediately and replace. Do not attempt to patch leaks, etc., as
6-4605
this could result in serious injury.
Pressure Relief Valve
Válvula de descarga de presión
4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only
Soupape de décompression
(Pump plunger 10-20 strokes and inspect for leaks).
5) Do: Direct shut-off away from you and open to make sure discharge is not clogged.
6) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank,
and proceed with Filling, Pressurizing and Spraying Instructions.
7) Do: Inspect all metal parts including the wand, nozzle and fittings for rust, corrosion and pitting.
If any of these conditions are found, replace affected part with original manufacturer's part
before using.
4. Filling
1) Do: Turn pump handle counterclockwise and remove pump
2) Do: Prepare spray solution following all directions and safety warnings on chemical label.
3) Do: Fill tank to no more than the proper gallon marker. Do NOT: over fill to accommodate pump.
4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank and
tighten securely.
018123R1021
1B
Outlet
Outlet
Tube
Tube
Discharge
Assembly
No
Outlet Tube
1D
1E
Gap
Adapter
Tab/
Retaining Nut - Se-
Tank
Notch
curely tightened.
Adapter
5. Pressurizing and Spraying
5A
5A
5B
5B
Do: Turn handle
Do: Pump until
clockwise to tighten.
you feel resis-
Push handle down,
tance.
turn 1/4 turn counter-
clockwise to release.
6. Fatigue-Free Spraying
For constant spraying, push down on shut-off handle
and move locking mechanism away from you. To
release, squeeze handle and move the locking
mechanism back towards you.
7. To Release Pressure
1) Your sprayer is equipped with a pressure relief/
7A
7A
release valve (Fig. 7A). To release pressure lift and
hold the cap until air is completely exhausted, OR,
turn the valve slowly counterclockwise until you
hear air escaping and wait air is completely
exhausted Fig. 7B).
2) Do: Stay away from the sprayer until all air has
escaped.
8. Wand Dock Clip
Choose the holder that fits your wand.
9. Care, Storage and Maintenance
1) Do: Follow chemical manufacture's instructions for cleaning. Rinse thoroughly with
recommended solvent. Follow Filling, Pressurizing and Spraying Instructions, except pump unit
only 8-10 strokes. Be sure that the wand and nozzle are thoroughly rinsed after each use.
2) Do: Open shut-off and allow recommended solvent to run through discharge assembly.
3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer.
4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.
5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through opening
in cover.
P.O. Box 549 700 Ellicott St.
Batavia, NY 14021-0549 U.S.A.
1-800-950-4458 www.chapinmfg.com
5C
5C
Do: Push handle, down,
turn 1/4 turn clockwise
to lock. Begin spraying.
Re-pump sprayer as re-
quired to maintain spray
force.
6A
6A
7B
7B

Publicidad

loading

Resumen de contenidos para Chapin 22180XP

  • Página 1 Congratulations! 1) Do: Turn pump handle counterclockwise and remove pump You have just purchased a quality Chapin product. Register Your Sprayer Online @ www.chapinmfg.com Questions? Do Not Return To Store. 2) Do: Prepare spray solution following all directions and safety warnings on chemical label.
  • Página 2 1/4 de vuelta en sentido contrario a las agujas del reloj para liberar (fig. 5A). réservoir. Vous avez acheté un produit de qualité Chapin. Enregistrez dès que possible votre pulvérisateur en ligne à l'adresse • Sí: Bombee hasta que sienta resistencia (fig. 5B).

Este manual también es adecuado para:

22170 xp22790xp