Daspi PASSAGE Manual De Instrucciones página 31

PASSAGE
CONTROL BOARDS' CIRCUIT
REVERSE MANEUVER ADJUSTMENT
1. The reverse gear has already been programmed. If the reverse force is
greater than the programming value, the door will automatically stop.
2. Press the knob, the door closes. Test the reverse gear, if it is too strong,
turn the potentiometer counterclockwise. If it is very soft, turn the
potentiometer clockwise.
3. When finished, run the engine several times to make sure that the door
moves normally in both directions and the adjustment made is correct. If
not, you will need to adjust the reverse gear force again until you reach the
desired setting.