Publicidad
Idiomas disponibles
Idiomas disponibles
As regards the information for the installation, operation, maintenance and disposal of the device, refer to
the following parts of the manual.
Parts containing active parts, except parts supplied with safety extra-low voltage not exceeding 12V, must
be inaccessible to a person in the bath.
The appliances should be supplied through a residual current device (RCD) having a rated residual
operating current not exceeding 30mA.
1.2 Pump
Do not change the place of pump on bathtub! Make sure the pump is pegged to the ground properly.
Do not start the motor without water in the pump in case you will get the seal damaged.
The motor will be hot when it is running, do not touch it!
Do not open the IC-Box when the motor is running in case you will get an electric shock.
The electrical network that be connected with motor should be accorded with nameplate of motor.
Warning: Make sure the pump is pegged to the ground properly!!
1.3 Air switch of Pump
Test it before each use. Keep all wires dry!
To reduce the electric shock, do not remove, modify or immerse this plug.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take this product for
environmental safe recycling.
1.4 Computer Panel
To make sure a longer lifecycle, please do not press the button continuously for a long time.
Do not cut off the power supply when the system is working. If something abnormal occurs after you
forced shut down the controller, just turn off the power supply for seconds and then start again.
9
Publicidad
