Publicidad
Idiomas disponibles
Idiomas disponibles
3. INSTALLATION
3.1 Before Installation
Open the packing cartons to check whether the bathtub has defects, and the availability of fittings.
Install the cap of switch, hand shower, faucet.
Put the bathtub into a pre-determined place.
The hot and cold water supply device should be located in a hiding place of bathtub body, through hose to
connect with hot and cold-water connection. (If poor water it should be installed water filtrating
equipment.)
Lead the drainpipe to the preformed floor drain. Then set the bathtub tube into the right place. Do not
extruding bending, chocking drainpipe, make sure the bailing smoothly.
Carefully hand tight the white drainpipe until stops. Do not over tighten. If possible, better to do it by
silicone or seal strips to avoid water leakage.
Put the plug into the socket.
Adjust the foot to make the bathtub at a horizontal position stabled.
3.2 Installation Steps
Open the package, and find a small box. Install the three switches, hand shower and faucet on bathtub.
Confirm the place of water, power and drainer. Install water pipe, drainer, and plug in right place.
12
Publicidad
