Peg-Perego Booklet 50 Instrucciones De Uso página 19

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING!
_ IMPORTANT: Keep these instructions for future
reference. Read and keep them for safety use.
The child's safety could be at risk if these
instructions are not followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This product is approved for children from birth up to
a weight of 15 kg in the seat.
_ For new born babies is recommended to use the
backrest in the most reclined position.
_ The Booklet 50 is designed to be used with Ganciomatic
Peg-Perego products: Booklet + "Primo Viaggio SL" (group
0+) car seat, suitable for children from birth to 13 kg.
_ When used in combination with car seat (0+ group ),
this vehicle does not replace a cot or a bed.
Should your child need to sleep, then it should be
placed in a suitable pram body, cot or bed.
_ WARNING Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use.
Check that the Peg Perego Ganciomatic product are
correctly fixed to the item.
_ WARNING The assembly and preparation of the
product must be carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING Always use the restraint system. Always
use the five point harness. Always use the harness
crotch strap in combination with the waist strap.
_ WARNING Never leave your child unattended.
_ Always apply the brake when stationary.
_ WARNING Ensure that all the locking devices are
engaged before use.
_ WARNING To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING This product is not a toy. Do not let your
child play with this product
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest ... ).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions regards the maximum
loads transportable.
_ The front bar (if present) is not designed to support
the child's weight. It is not designed to keep the child
in the seat and does not substitute for the waist belt.
_ Do not load the baskets over 5Kg. Do not put weight
in the cup holder (if present) in excess of those
indicated on the cup holders themselves and never
hot drinks. Do not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING Don't use the rain cover (if present)
on a product without a hood or parasol that can
hold it. Always use the rain cover only under adult
supervision. Don't use the rain cover indoors and
check to ensure the child is not to warm; do not
park the vehicle close to heat sources and keep well
away from the lighted cigarettes. Ensure that the rain
cover is not interfering with any moving parts of the
carriage/stroller. Always remove the rain cover before
folding your carriage/stroller.
_ WARNING This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING Do not add any mattress are not approved
by the manufacturer.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
INSTRUCTIONS
1 OPENING: Before opening the frame, remove (without
using blades) any die-cut cardboard.
WARNING:
_ DO NOT PULL OR FORCE THE FASTENER BEYOND ITS
LIMIT.
_ DO NOT USE THE FASTENER AS A CARRY HANDLE OR
TO CARRY WEIGHTS.
DO NOT HANG BAGS OR OTHER ACCESSORIES TO THIS
FEATURE.
Press down the side fastener, hold the upper section of
the handle and rotate it towards you until the frame is fully
opened (fig_a). Open frame (fig_b).
The frame is properly opened when the attachment on the
base clicks into place, as shown.
2 FITTING THE WHEELS: Slot the uprights into the rear
wheel crosspiece (fig_a), ensuring that it is facing the
right way, then push the rear wheels on and make
sure that they click into place (fig_b). To mount the
front wheels, fit them into the uprights until they lock into
place (fig_c).
3 ATTACHING THE MAIN HANDLE: if the handle tube
faces upwards, align it with the stroller (Fig_a).
Fasten the handle to the frame as shown in the figure
(Fig_b).
To complete the operation, press the two side buttons
on the handle (Fig_c) to ensure the handle pushes in
all the way, until it clicks into place (Fig_d).
4 BASKET ASSEMBLY: to facilitate basket assembly, pull the
tab outwards and lift as shown in the figure (fig_a).
Slip the basket flap into the slot along the front bar of
the chassis (Fig_b).
5 Fasten the basket eyelets to the buttons on each side
of the frame.
6 To complete the basket attachment procedure for the
front part, you are required to insert the supplied tie
(fig_1) as follows:
position it between the basket and buttons, as shown
(fig_2) and use your finger to push downwards, so as
to complete the attachment procedure (fig_3).
Repeat the same procedure for the other side of the
basket.
7 Attaching the rear part of the basket.
Remove the card from the rear bar.
Fasten the upper basket eyelet to the button on each
side of the frame (Fig_e).
Fasten the basket's two lower eyelets to the two
buttons on the rear bar of the frame (Fig_f).
8 Basket fastened correctly (fig_g).
Lastly, re-position the footrest, pressing inward with your
hand as shown in the figure (fig_h).
It is possible to increase the basket capacity by pulling the
tab outwards (fig_i).
WARNING! If you do not hook the basket on correctly,
as shown, the basket will be unable to support the
weight of loads placed in it.
9 HOOD: Fasten the back of the hood with the Velcro strip
(fig_a), insert the hood fasteners into their slots (fig_b),
secure to the buttons inside the handlebar with the rubber
band (fig_c) and button the hood to the side of the frame
(fig_d).
10 Supplied with two parasol sections. To open, pull forwards
(fig_a).
The hood includes a loop to be used to hang your child's
favourite toy (fig_b). You can detach the Velcro, roll up the
back of the hood and fasten it at the top with the rubber
- 19 -