Radio; Receiving Preset Stations; Best Stations Memory (Bsm) - Pioneer MVH-X380BT Manual De Instrucciones

NOTE
The options vary depending on the unit.
Menu Item Description
FM STEP Select the FM tuning step from 100 kHz or 50 kHz.
[100], [50]
SP-P/O MODE Select when there is a full-range speaker connected to
the rear speaker output leads and there is a subwoofer
[REAR/SUB.W]
connected to the RCA output.
[SUB.W/SUB.W] Select when there is a passive subwoofer connected
directly to the rear speaker output leads and there is a
subwoofer connected to the RCA output.
[REAR/REAR] Select when there are full-range speakers connected to
the rear speaker output leads and RCA output. If there is
a full-range speaker connected to the rear speaker
output leads, and the RCA output is not used, you may
select either [REAR/SUB.W] or [REAR/REAR].
S/W UPDATE Select to update the unit to the latest Bluetooth
software. For details on Bluetooth software and
updating, visit our website.
SYSTEM RESET Select [YES] to initialize the unit settings. The unit will be
restarted automatically.
[YES], [CANCEL]
(Some of the settings will be retained even after
resetting the unit, such as Bluetooth pairing information,
etc.)

Radio

The tuner frequencies on this unit are allocated for use in Western Europe,
Asia, the Middle East, Africa and Oceania. Use in other areas may result in poor
reception. The RDS (radio data system) function only works in areas that
broadcast RDS signals for FM stations.

Receiving preset stations

1
Press SRC/OFF to select [RADIO].
2
Press BAND/ to select the band from [FM1], [FM2], [FM3], [MW] or
[LW].
3
Press a number button (1/
TIP
The / buttons can be also used to select a preset station when [SEEK] is set to
[PCH] in the FUNCTION settings (page 17).

Best stations memory (BSM)

The six strongest stations are stored on the number buttons (1/
1
After selecting the band, press the M.C. dial to display the main menu.
2
Turn the M.C. dial to select [FUNCTION], then press to confirm.
3
Turn the M.C. dial to select [BSM], then press to confirm.
To seek a station manually
1
After selecting the band, press
Press and hold / then release to seek an available station.
Scanning stops when the unit receives a station. To cancel seek tuning,
press / .
NOTE
[SEEK] needs to be set to [MAN] in the FUNCTION settings (page 17).
To store stations manually
1
While receiving the station you want to store, press and hold one of the
number buttons (1/ to 6/
to 6/ ).
to 6/
/ to select a station.
) until it stops flashing.
).
7
En