Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting Handpiece (Fig. 3)
1. Slide handpiece onto coupler.
2. Press fi rmly until it snaps into place.
Note: Handpiece should swivel freely with slight tension and sit fl ush on coupler.
Removing Handpiece (Fig. 3)
Hold ring on coupler and pull handpiece straight off.
Note: Do not hold or pull on hose.
Changing Burs ( Fig. 4)
• Only use ISO standard burs with shank diameter of .0628" - .0630" (1.595mm-1.600mm).
• Do not use bent, worn or damaged burs.
• Always keep burs clean. Dirt and debris on shank may cause clogging/sticking, loss of grip or premature wear of chuck.
• For standard head handpiece, use standard shank burs; to prevent bur breaking off in chuck assembly do not use short
shank burs.
6 EN
Release Ring
Fig. 3
Publicidad
