Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING UP THE BASSINET (continued)
2
D
E
3
G
F
G
G
C
G
4
A
4
Place the bassinet
on the floor with tubes and sleeves facing upward.
C
Note: Tubes are pre-installed on the bassinet and require only to be
connected.
Connect one set of tubes
and
together, as shown. Make sure they
D
E
are securely connected. Repeat for the other set of tubes.
C
D
E
WARNING
To prevent injury or death, NEVER set up the bassinet with
the child in the playard. ALWAYS remove the child from the
playard before installing the bassinet.
Place the bassinet
into the playard
with the tube assemblies
C
F
on top, as shown.
Make sure all eight hooks
are securely attached to the rails, as
G
shown.
WARNING
To avoid serious injury or death:
• NEVER use the mattress pad cover without the mattress pad.
• Check to ensure bassinet is fully secure by firmly pressing down on all
four corners of the mattress pad.
• DO NOT use bassinet with children over 15 lbs (6.8 kg). Discontinue use
when child begins to push up on hands and knees or can roll over.
• FALL HAZARD: To prevent falls, do not use this product when infant
begins to push up on hands and knees or has reached manufacturer's
recommended maximum weight, whichever comes first.
Place mattress pad
on the bassinet, cushion side up. Push down firmly
A
on all four corners of the mattress pad.
1
C
B
2
B
A
B
B
D
SETTING UP THE CHANGER
Place the changer
on the floor, as shown.
A
Note: Tubes and fastening clips are pre-installed on the changer
A
and require only to be connected.
Insert one tube
into its corresponding fastening clip
C
Make sure the tube end locks into the fastening clip with an
audible click. Repeat for the other tube and fastening clip.
Fasten Velcro to cover tubes.
R
B
R
WARNING
• FALL HAZARD–To prevent death or serious injury,
NEVER leave child unattended. ALWAYS keep child
within arm's reach.
• NEVER leave changing table in place when child is in
the playard or bassinet. To avoid serious injury or death,
ALWAYS remove the changer from the playard or
bassinet after each use.
Note: Changer can be attached to either end of the playard.
To install the changer
to the playard, unfold the fastening
A
clips
. Locate the "L" inside the Left clip, and the "R" inside
B
the Right clip.
Push each clip onto the top of the playard as shown. The Left
clip attaches to the Left side of the playard, and the Right
clip attaches to the Right side of the playard. Make sure both
fastening clips lock securely into place with audible clicks.
Note: Changer will attach in one orientation only. If the changer
will not attach to the playard, make sure you have the Left clip
on the Left side and the Right clip on the Right side.
After attaching the two clips to the playard, fasten the
changer skirt to the playard with the two snaps
.
B
.
D
5
Publicidad
