8
www.electrolux.com
C
Digit
area:
D
Washing programme phase indicators:
By selecting the wash programme, the washing programme indicators corre‐
sponding to the various phases making up the programme are shown.
After you have pressed the Inicio/Pausa button, only the indicator of the running
phase stays on.
E
• Duration of the selected programme
After you select a programme, the duration is displayed in hours and
minutes (e. g.
the basis of the maximum recommended load for each type of fabric.
After the programme start, the time remaining is updated every mi‐
nute.
• Delayed start
The selected delay appears for a few seconds, then the display
shows the duration of the selected programme again.
• Alarm codes
In the event of operating problems, some alarm codes can be dis‐
played, e. g.
• Incorrect option selection
If you set an option not compatible with the selected wash pro‐
gramme, the message
red indicator of button Inicio/Pausa starts flashing.
• End of programme
When the programme has finished, three flashing zeros
displayed and the indicator of button Inicio/Pausa goes out.
If the indicator
Wash
Rinses
Drain
Spin
During the washing cycle the display shows a temperature icon indicat‐
ing that the appliance has started the heating phase of the water in the
tub.
). The duration is calculated automatically on
(see chapter «Troubleshooting»).
shows up for a few seconds and the
goes off, you can open the door.
are