Publicidad
Idiomas disponibles
Idiomas disponibles
9.
Tank Full Indicator
10. Lock Indicator
Power button
•
Standby mode:
As you plug the appliance into the power
supply, it will beep and all the indicators
will flash on and then off. The power
indicator will be on in the top right-
hand corner of the LED display. Your
appliance is now in standby mode.
Turning on:
Press the power button to turn on the
appliance. Its default mode will be
automatic mode, with high wind speed
and humidity of 60%. The appliance will
start up in the mode selected when the
unit was last used.
Turning off:
Press the power button to turn the
appliance off.
Unplug the appliance if it will not be
used for extended periods.
Mode button: Press the mode button
•
to cycle between different modes. The
corresponding indicator will light up.
Auto mode:
In this mode, when the environment's
humidity exceeds the set humidity by
more than 3%, the fan will automatically
5 | English
HUMIDITY
turn on and 3 seconds later the
compressor will start working. The
appliance will automatically turn off if
the environment's humidity is 3% lower
than the set humidity. You can adjust the
fan speed and humidity settings in this
mode.
Continuous drying mode:
In this mode, the appliance will be on
and the set humidity cannot be changed.
Sleeping mode:
In this mode, after 10 seconds all
indicators will turn off and the wind
speed will change to low. Touch any
button to bring the indicator lights back
on. In sleep mode, error codes will not
be displayed, and the wind speed is not
adjustable. The humidity settings are still
adjustable.
HUMIDITY button
•
While the appliance is on, in auto
mode or sleep mode, press the
humidity button to cycle through the
humidity settings. These will display
on the display panel in 5% increments,
between 30% and 80%. When you
reach your target room's humidity, it will
set after 5 seconds of no other buttons
being pressed.
Publicidad
