Publicidad
Idiomas disponibles
Idiomas disponibles
Long press the humidity button to view
the current room temperature on the
LED display. After 5 seconds, the LED
display will revert to the current humidity.
LED display
•
The numbers on the LED display will
show the current humidity of the room,
the hours set when setting a timer, or the
temperature when the humidity button is
held down. The icons around the
numbers will indicate the fan setting,
mode, and if the child lock is on.
Timer button
•
Press the timer button to cycle between
1 – 24 hours, in increments of one hour.
The hours set will be displayed on the
LED display.
When the LED display reads '00', the
timer is turned off, and the indicator will
turn off.
While the appliance is on, set the timer
to turn the appliance off.
While the appliance is in standby mode,
set the timer for the appliance to turn on.
Fan Speed button
•
In auto mode, press the fan speed
button to switch between high and low
fan speed. The corresponding indicator
will light up.
Lock button
•
Long press the lock button to activate
child lock. All buttons on the appliance
will be locked and the child lock
indicator will be on.
To remove child lock, press the lock
button again. The indicator will turn off.
Child lock will be turned off when the
appliance restarts.
Note: The appliance will start up in the mode
selected when the unit was last used. The
appliance will not start if the water tank is not
fitted in the unit correctly. The compressor's
start is delayed by 3 minutes after the start
of the fan.
Colour Display:
The light will display different colours
according to the ambient humidity of the
environment:
Blue – Below 45%
•
Green – Between 45% and 65%
•
Red – Above 65%
•
Note: The light will also be red if any of the
error codes are displayed on the LED display.
See the 'error codes' section for more
information.
English | 6
Publicidad
